Termékek kávézó berendezési elemek (6)

During the construction of an industrial facility, much attention is paid to the strength of the service pipelines fasteners. It is also necessary to provide reliable connection of all units of industrial equipment with the pipelines. In this case, it is not always possible The use of a permanent welded joint is not always possible, therefore, there are various types of weld-free tight joints. FLANGE JOINT COMPONENTS At present, one of the most effective connections used in industrial facilities is a flange joint. This is an airtight connection that provides high structural integrity, consists of two flanges, fasteners (studs or bolts, washers, nuts) and gaskets. An important matter in choosing a set of flanges is tightness. The gasket material must have good elasticity, strength, resistance to the operating temperature conditions and to the media with which direct contact is expected. For flange joints, Villina company uses the following types

We supply thrust bearings (bearing plates, end thrust bearing), rolling bearing (combined type) and support bearings (plain journal bearings) made of the following material: tungsten carbide (WC); silicon carbide (SiC), VK8 alloy, etc.

The magnetic coupling drives for stirring devices are designed to be installed immediately into the tank and provide the necessary stirring of the product. The drive is electrically driven and consists of two half-couplings (driven and driven magnetic half-couplings), bearing assembly and the stirring device itself. Stirring devices (mixers) are of several types: paddle, anchor, propeller, U-type, etc. We develop and supply turn-key solutions for our customers. Magnetic coupling drives for stirring devices are custom-tailored for each specific customer's application in accordance with the sketches provided or according to the parameters specified in the questionnaire form.

We supply rubber sealing O-ring comforming with GOST 9833-73 “Rubber sealing O-rings”. We produce: flat paronite and fluoroplastic gaskets in accordance with GOST 481-80 high-temperature TEG (thermally expanded graphite) gaskets according to STO 00220575.001-2007 heat-resistant spiral-wound gaskets according to GOST R 52376-2015

We offer bowls and impellers for centrifugal pumps made of: steel 20H13L, steel 12H18N9TL, steel 12H18N12M3TL according to GOST 977-88.

We produce shafts for pumping units made of the following materials: steel 20H13, 30H13, 40H13 as per GOST 5632-2014; GOST 5949-2018; 14H17N2 as per GOST 5949-2018. Shafts made of other materials are also available subject to prior agreement. Subject to preliminary agreement, we are able to supply larger diameter shafts. All parts are manufactured according to drawings. Maximum length:up to 2 meters Maximum diameter:100 mm